Scoping and screening in environmental impact

The Environmental Statement must include the information that may reasonably be required to enable the local planning authority or Secretary of State to come to a reasoned conclusion on the significant effects of the proposed development on the environment. Certain designated sites are defined in regulation 2 1 as sensitive areas and the thresholds and criteria in the second column of the table in Schedule 2 are not applied.

Removal or demolition of disused structures that may be used by roosting waterfowl. There should be early discussions with them regarding possible alternative s that are likely to cause the least ecological damage or result in the greatest benefits.

Consideration should be given to the best methods for the engagement of stakeholders and the terms of reference for doing so, to enable an open process to take place with no surprises. An applicant is not required to consult anyone about the information to be included in an Environmental Statement.

Establishing the Zone of Influence 2. Infrastructure links between an offshore location and terrestrial networks e. Such consultation will facilitate evaluation of the scope and methods of any investigations that may be needed to consider alternatives.

Where a scoping opinion or direction has been issued, an Environmental Statement must be based on the most recent scoping opinion or direction issued, so far as the proposed development remains materially the same as the proposed development which was subject to the opinion or direction.

It is the responsibility of the local planning authority or the Secretary of State, as appropriate, to perform their duties under the regulations in an objective manner, avoiding conflict of interest.

Once an applicant has given the local planning authority notice under regulation 17 1 that it intends to submit an Environmental Statement, the local planning authority must inform the consultation bodies and remind them of their obligation to make available, if requested, any relevant non-confidential, information in their possession.

Structural works to existing structures, including conversions. This can considerably reduce consultation time and avoid delays caused by stakeholders requesting additional survey or other work at a later stage.

The fact that a particular development is not specifically identified in one of the Schedules does not necessarily mean that it falls outside the scope of the Regulations. Regulation 16 sets out the procedure for requesting a scoping direction.

Release of contaminants from disturbed sediments. The main findings must be set out in accessible, plain English, in a non-technical summary, to ensure that the findings can more readily be disseminated to the general public, and that the conclusions can be easily understood by non-experts as well as decision-makers see regulation 18 3 e.

Note that positions should be geo-referenced to latitude and longitude and the datum s used e. In practice, the likely environmental effects of Schedule 2 development will often be such as to require an Environmental Impact Assessment if development is to be located in or close to sensitive sites.

Environmental Impact Assessment

Cumulative impact assessment is discussed in Chapter 5. An expansion of the same size as a previous expansion will not automatically lead to the same determination on the need for an Environmental Impact Assessment because the environment may have altered since the question was last addressed.

Any particular persons or bodies including non-governmental organisations promoting environmental protection whom the local planning authority is aware are likely to be affected by, or have an interest in, the application, but are unlikely to become aware of it through a site notice or local advertisement, should be sent equivalent information to that publicised in the newspaper notice, so that they may obtain a copy of the Environmental Statement and comment or make representations if they wish.

What were their historical distributions, status and management compared with the present? Noise and vibration from piling activities.

Environmental Impact Assessment (EIA)

Runoff containing contaminants or sediments. For example, the Schedule 2. Further information about the definition of baseline conditions and cumulative impact assessment is included in Chapter 5.

Institute of Ecology and Environmental Management

The consultation bodies are only required to provide information already in their possession. Therefore, where it becomes evident during the assessment process, for example, when undertaking a baseline survey, that a particular environmental factor is absent or unlikely to be significantly affected by a proposed development, there should be no need for further assessment of that factor even though it was identified in the scoping process.

The purpose of the Environmental Impact Assessment Directive is to assess the significant effects of a development on the environment. Assembly areas for components of construction.

Potential non-standard operations e. All developments in, or partly in, such areas should be screened. If it is considered that the change or extension will not lead to other significant adverse effects, taking into account the effects on the development as a whole, screening should not be required where the change or extension does not meet the criteria or thresholds in Schedule 2.03 Environmental Impact Assessment: Screening, Scoping and Preliminary Environmental Information July Version 4 EIA development (known as a screening request)4; or • informed the Secretary of State that an Environmental Statement (ES) will accompany their DCO application, in.

Environmental impact assessment is a formal process used to predict the environmental results, both negative and positive of a plan, policies, and programs, it propose measures to adjust impacts to acceptable levels or to investigate new technological solutions. Having completed the screening exercise, the local planning authority must provide a screening opinion, indicating either that an Environmental Impact Assessment is required (a ‘positive.

Scoping is the process used to determine the appropriate contents of an Environmental Impact Statement (EIS). Public participation is an integral part of scoping.

The first scoping step is to announce to the public, by a Federal Register notice and press releases, that an EIS will be prepared and to ask for comments about what should be. Raising the profile of professional ecological and environmental management and promoting the highest standards of practice for the benefit of nature and society.

Screening and Scoping; Screening and Scoping. Screening for EIA Scoping What is scoping? likely significant impacts on known biodiversity, their inter-relationships. The screening and scoping of Environmental Impact Assessment and Strategic Environmental Assessment of Carbon Capture and Storage in the Netherlands.

Download
Scoping and screening in environmental impact
Rated 0/5 based on 16 review